Note: the item is not inclued Built-in battery, does not support Bluetooth. (Because of the airspace controls not included battery). 100% Brand New And High Quality.
Radio enthusiasts an essential tool for entry. Test the antenna technical parameters. Can test the standing wave, impedance, capacitance and so on. Can be connected to the computer to do antenna and other graphic analysis. Power supply: External: 13.8 to 19 Volts DC, 500mA; Internal: 8xAAA 1000mAh NiMH cells.
Charging time: 12 hours (charge rate 0.1C). SWR, impedance (resistance + reactance), capacitance, inductance.
Measure coax transmission line (SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance). Measure and determine optimum settings for tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance. 12V - Driveable talent works, but can not charge the battery.
3.8V 18V - can drive the talent to work normally, can also be normal for the battery charge. Spectral Purity: Harmonics down Greater than - TBD dB beyond 60 MHz.Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz. SWR: 1.0 to 9.99. RF Output: Adjustable: 2.0 Volts pp (typ). Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down". External power: 2.1mm Power Jack (center pin positive). Measure ground loss: Adjust antenna tuners and determine loss.
Determine characteristic impedance of transmission line. Determine length of ¼ and ½ wave phasing lines. 1 x MR300 1-60MHz HF Antenna Analyzer. Please Make sure it's 100% right.
Please leave note for your special request e. But the items must be back in factory condition. If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Other Ham Radio Equipment".
The seller is "worldchips" and is located in this country: CN. This item can be shipped worldwide.